I am working on a Phaser 7500 and currently it prints fine on all of the colors except for Magenta and Black. On the magenta when looking at the page in landcape there is a white line that goes across the top part of the page about an inch or two from the top. The same thing occurs with the black, however the black is a thinner line and occurs slightly closer to the top. I have replaced all of the imaging units as well as the fuser. I also have cleaned the LED head assemblies as well with the pull tabs as indicated by the instructions on the support site.
This is stumping me, because i have replaced just about every part i can think of that would cause this.
Can i get any insights?
Also i can provide pictures if needed as well when i print the solid color pages (it's where it shows up the clearest)
Thank you for using the Support Forum. Please take a look at the solutions for lines and bands. Also please see the solutions for more repeated lines. If these solutions do not help please consider contacting your support centre for further assistance.
Thank you for replying to my post. However as indicated above. I have already tried the solutions for the lines and bands and for repeated lines. I have went through the troubleshooting provided by the Xerox site with out any success. Which is why i posted here for assistance.