Password admin, login to administrator panel

[AB89]

1. From the printer’s control panel, press Settings.
2. Press Device.
3. Press Maintenance.
4. Press Out of Service Erase.
5. Place a check mark on the Sanitize all information on nonvolatile memory option and press Okay.
6. Place a check mark on the Start initial setup wizard and press Okay.
7. The printer will display a screen indicating that the machine is restarting. You will be prompted on startup to walk through the device’s initial setup wizard.

From the Embedded Web Server:

1. From a computer (on the same network as the printer) open a Web browser.
2. In the Web browser address field, enter the IP address of the printer and then press Enter or Return. The printer home page will be displayed.
3. Click Settings.
4. Click Device.
5. Click Maintenance.
6. Place a check mark on the Sanitize all information on nonvolatile memory option.
7. Click Start.
8. The printer will display a screen indicating that the machine is restarting. You will be prompted on startup to walk through the device’s initial setup wizard.

Note: If the issue persists, power off the machine, wait for 30 seconds and power the machine back on. Then repeat the procedure.

[skwat]

Hi,

I have allmost the same problem, but i cannot reset the admin passsord, every thing is locked.
When i try to connect to the web interface, i have a message "This feature is locked. Log in to your account and try again.", and on the touch screen every fonction locked !!!!

How to make a hard reset of the printer ????

> i finally found the admin password i have set during initial setup :-) but i would like to know how to make a hard reset of the printer

[AB89 · Accepted solution]

RESOLVED

I found instruction to reset and unlock password. This resolved my problem. Printer working :)

https://www.support.xerox.com/en-us/article/en/2139003

[AB89]

Hello, I recently purchased a Xerox B235 MFP multifunction printer for my company. Unfortunately, I am not able to log into the device settings. I do not know what the factory administrator password is (and what login ... whether upper or lower case ...). This information is not in the manual.
I tried 1111, I tried the serial number, admin / admin combinations. I also did a software update. No effect. I am asking for help ... why do I need such a printer if it cannot even set the IP address: /