I have the same problem...
I have the latest firmware V3.50.21.03, and don't please provide me with information on how to setup the printer like in the below message.
I also disabled Direct wifi and set standby for 60 minutes....
I've bought two of the new Phasers 3020 and have the same problem with both of them. Since I have two old Phasers that work fine seems like the problem is in the firmware. The old printers have firmware V3.50.01.08 while the new ones have the latest V3.50.21.03.
Is it possible to get and update to the OLD firmware? Specifically, V3.50.01.08 that works perfectly well even with the latest Win11.
Have you looked at upgrading the firmware on your device?
all information above is useless. the printer has firmware issues. WIFI is lost after printer enters in standby mode.
If you are still having issues after trying these steps, I suggest that you call into our support department for assistance @ 1-800-835-6100.
This printer is brand new. The bar below the exclamation mark is green, the WPS button no longer flashes blue.
When I tell it to print something, nothing happens.
If I press the power button once, it starts to make some noise and then the WPS button is blue again and the bar below the exclamation mark is green. But still, if I tell it to print something, it won't.
Only when I hold down the power button for like 10 seconds, the printer is turned off, then press the power button again, then the printer is turned on again, will the printer start printing again.
Can someone help make sense of this? Super weird