I contacted support about this, but they refused to answer as I'm a month past warranty, so I'm guessing its a major issue. Hoping someone on the forums had the problem while under warranty and can share what support told you.
My Phaser 6022 when it goes into sleep mode does not wake when a print job is sent to it. I have to power it off, and back on, then the print job goes through. This is while connected by USB or using WiFi. If I hardwire to the network, it works fine.
When it is like this, the menu is unresponsive/frozen, you can press all the buttons you want and it won't wake.
I've installed the lastest firmware hoping for some improvement, but nothing changed.
If anyone else had this problem, could you share what was needed to fix it?
Hi Casper 2017,
Thank you for using the Support Forum. Please make sure that you have the latest firmware loaded on your machine. If upgrading the firmware does not help please consider adjusting the power save mode to a longer time to see if that will fix the problem.