I noticed that my navy blue prints ate coming oyt a bit green.
I did a test using large bold text in a word file.
Blue camne out blue, Red came out orangy/tan, Green is green and black is black.
All my toners are full, my imager has 95% to go, fuser 85% to go transfer os OK.
How can I get my red back.
I would suggest following the calibration instructions found in sections 4-16 and 4-17 of the following manual:
They are simple steps to complete. This will give you a good starting point.
If further correction is needed, see section 4-15 to see adjustments that can be made through the driver.