Printing on felt cover stock...

[nobiuspress]

Thank you for the help.

Tony

[Joe Arseneau · Accepted solution]

Isn’t supported but can be done in limited quantity.

It’s a “make the number bigger to it likes it” method as it were.

Should work on any stock with indents and or fold marks where the toner does not lay in the creases, or rough textured paper

To do that, go to the copier and log in as the admin.

Then go to Machine Status > Tools > Common Service Settings > Paper Tray Settings > Custom Paper Settings

Choose one and give it a name, and adjust the Adjust Image Transfer setting

 

Usually the percentage needs to be raised, I suggest going in increments of 10% for both sides until you get a number that works with your stock

Then load a tray and choose the created Paper type from the list. (I called mine Linen in the above steps because this whole write-up is from a Linen question ;-) )

[nobiuspress]

We have a Color C75 Press. I am trying to run an 80# Felt Cover though and the coverage is all blotchy. It is having a hard time printing into the slight dimples or depression. Is there any printing techniques I can use to get better coverage or is this stock not going to work?

Thanks