cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New Member
New Member

Problem with Phaser 6360

Hello everyone,

 

I very much appreciate any help.

 

My office's Phaser 6360 is stuck in "warm up" mode. Despite power / network cycling it doesnt seem to leave this mode except very breifly when restarted. After a restart, it will usually print a "status" page, then print its backlog, then go immeidately back into "warmin up" mode.

 

Any help would be very much apprecaited, thank you.

0 Kudos
1 Reply
Highlighted
Valued Advisor
Valued Advisor

Re: Problem with Phaser 6360

Try starting with it unplugged from the network, if that fails, reboot after putting back on the network and see if you can reach it by webrowser to load it's embedded web interface (Put its IP address in you web browser of choices address bar), if that works, and appears stable, grab the firmware from Xerox.com drivers page and attempt to update it.

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe Arseneau
0 Kudos