Removed and reseated fuser and no problems yet. 2600 pages without stripes!
Funny, I didn't pay attention to the fuser because I didn't see the connection between fuser and the colored stripes on the page...
Try to remove and reseat the fuser and if the issue is not solved replace it.
MFP Xerox Versalink C7030 prints with color stripes, but not on every page. Approximately 40 copies - 1 page with stripes. It happens that out of 10 pages, 2 will be with stripes, and sometimes 100 will print and not a single stripe. From different programs such as AutoCad, Word, Excel... Stripes appeared when there were about 100,000 copies. The device passes all tests without errors, and it was not possible to get stripes on the test pages.
What did I do:
1. I cleaned the device;
2. Replaced Drum Cartridge (113R00780);
3. Replaced Transfer Belt (115R00127);
4. Out of desperation, I took up software. Updated the drivers and updated the firmware on the device;
5. Performed color calibration and transfer belt calibration.
Unfortunately, this replacement did not solve the problem. At some point, the stripes stopped appearing, but a month passed and they appeared again, although they did nothing with the device.
The only thing that hasn't changed is the developer unit assembly (607K07290) and fuser.
Counts print copies now - 150467
I don't know what to do anymore. Any ideas?
Solved! Go to Solution.