Trying to set up wirelss printing but IP address resets to 127.0.0.1

[sdwizard1]

I am having this same issue. The printer shows connected but signal strenght is 0%. Was there a solution to this issue. When it converts to the 127.0.0.1 ip address, it kicks me out of the admin console and I cannot reconnect. Please help. 

[loco]

Hi there!

Are you trying to use wired and wireless at the same time? The wired connection will be always your primary.

[CathyO-Xerox]

Hello jmb,

I searched the Knowledge-base and found some solutions you can try:

https://www.support.xerox.com/en-us/article/en/1560268.html

https://www.support.xerox.com/en-us/article/en/1561877.html

https://www.support.xerox.com/en-us/article/en/1227056.html

https://www.support.xerox.com/en-us/article/en/1227349.html

If none of these help you, I would recommend contacting our Support Department.

[jmb]

When I am trying to enable wireless printing via the Workcentre, when I enable wireless, my ip address resets to a generic ip on my printer of 127.0.0.1.  When I try to print, it says my printer is offline.

Any ideas of how to fix?