here you have the setting for offline/online changes.
Please be aware that you are not mixing the device offline functionality with energy saver features and that the device is going into power save, disabling the network controller therefore being offline. If this is the case the device should resume once a job is sent to the device.
Below you can access the link with instruction who to set it up.
Something is wrong because we have a firmware version different from the last on the web:
We had no problems with the previous version. I tried to do a downgrade but it fails.
Version: 061.121.222.32600 is an upgrade from the one on the website. 061.121.222.06507 is latest general release. Since than small modifications are implemented in additional version until a new general revision is released.
To donwgrade you normally would require and engineer to do it. As there is a special technical mode to perform. Nevertheless some models allow downgrade via USB. Make sure you doing it at your own risk. Taking into account backup of data and features.
The latest version for your device can be found here: 061.121.223.04302
Great. I am happy for you. :)
I could not find this 061.121.224.04302 version. can you be sure it is on the support.xerox.com page.
I am getting the same problem with a 7545 randomly setting itself to Offliine.
I need this version of software and can not find it.
can you supply me the link. thanks
Have you tried the latest version from HERE?
Please remember to select "Accept as Solution" for posts that helped you solve the issue.