I believe they released a new baffle (metal plate at the bottom of the IBT. You have to ask your CSE to order it for you.
I found on another forum that this issue is know to Xerox and has been labeled "trail edge flick". There was apparently a service bulletin regarding it in 2013. Do you have any info regarding that bulletin?
I have a Xerox 800 ColorPress
I am running a short sheet 11 x 15 (12 point - 225 gsm). At the center tail of the sheet I am getting a curved mark. It doesn't seem matter which side of the sheet prints first and it's always in the same position at the tail of the sheet. I removed the curved shield over the IBT belt and it stops the mark but the 2nd BTB belt shreads itself. So the sheet is definately bumping that shield, but how do you solve it?
Also, I am losing color at the very tail end of my image (within the last 1/2" of the sheet). I tried to move around the value of the 2nd side bias in the advanced paper properties which helps but doesn't cure the issue.
I also tried tricking the machine by telling it my paper was thicker than it actually is. The problem doesn't go away and I start to lose image quality elsewhere.
Any ideas? I have a lot of paper to run.
Thanks for any assistance.