Luckily the latest firmware always resides at the same link, so if I give you the links now, they will go to 100.XXX.097.25400. But later, when the next release comes, they will go to it instead.
So bookmark the ones you need, and when the end number changes from 25400, download and install (and hope)
And thanks for chiming in Fabio, it's nice to have a backup in this place ;-)
there is a new GENERAL release out, release date 10/10/2017 , version : xxx.09609
again new color impromants, copy is also better
now if you make a copy of a copy, there is still a print on it :) , before after making a copy of a copy of a copy, there was no black anymore :)
you can dowload it on www.xerox.com/support , search for altalink C80xx , support é drivers, firmwares ...
100.xxx.xxx.28600 just released and has many color fixes.it is currently caching at the above links, so it may be available now, or in the next few hours. (Just don't bother downloading until it resolves to the firmware that ends in 28600
Thanks Joe. Quick question. Are there any release notes we can download as well for this that document some of the changes? The last PDF we downloaded for info was for 100.xxx.057.09609.
attached
Just tried the newest firmware on our AltaLink C8070, v100.0030107.28600, it's getting better but still not nearly as good as the copies and prints we used to get from our WorkCentre 7556. There seems to be a major issue with the darkness of what grey should look like, objects with low line weights come out almost invisible. We use varying levels of grey from 10% to 100% black in our prints, so distinguishing between them is important.
Any thoughts? or just keep waiting for a better firmware update?
I would also have a tech come in and run tests. Besides calibrating for copies and prints they also run internal calibration procedures.