Yes, it can be a problem. So, use original.
I used NOT original Xerox belt with 7 stripes in it, original has 9 can that be a problem?
Use a ironsaw blade to clean the drive roller on the motor, maybe it helps, or increase the torsion on the spring,
I know cases when it was needed to replace 3 drum belts.
Got the same problem, also replaced the encoder with no success,
finally, it was the pulley from the motor, witch was full of wear of parts from the belt rubber,
clean the pulley from the motor, and it should work
Hi, I have the same problem 094-534 where are these encoders positioned? My belt breaks off, i changed it, but still dont work...
Pls HELP :)
I am not a Xerox Service Technican,
but I have also 2 Colorqube 9301
I got the same problem 2times, you should reload the Systemsoftware per USB with ALTBOOT, maybe it will fi your issue, (was my problem), or check the harddisk, you can use a simple SATA harddisk, (located at backside in the Bay in the Middle (underside))
it looks like, this is your problem
hi Paul, i m italian xerox customer, i have problem whit xerox CQ 9303, when I turn on the copier, it always remains with initialization for hours, without being ready, what is its problem?
First, check the drum-belt first, clean the drive engine motor pully from belt rests,
and try a new belt, some people will rise the belt tension by adding a second spring, to
prever the pully from slipping, this will fix it some times, without spend much money