bars on tail end of sheet about 1 and a half inches in.

[interformdigital]

Printing 2 sided 13x19 or 12 x18 sheet cover stock i am getting a bar or addition on the tail end of the sheet. Is there an adjustment I can make some where to make this go away?

Thanks

kent

[GabiE-Xerox]

Hi,

Try to adjust the “Transfer output adjustment for trail edge” in Advanced Stock Setup in the Stock Library Manager.

Gabi

[interformdigital]

So its current setting is at 100 and i have gone down 10 each time i ran the stock until I got to 60 with no changes. do i have to change the speed settings while i change that other setting to?

thanks Kent

[GabiE-Xerox]

You can try to:

Run the media in a slower mode by selecting Cast or Textured / Embossed as the media type in Stock Library Manager

Adjust the size of the image to increase the border at the trail edge

Also it will be better if you can upload some images with the issue here on the Forum.