Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
2 Replies
charlieapps123
New Member
New Member
‎08-08-2016 07:11 AM

Re: iGen 5 -150 with Fiery RIP Cycles down between sets with separator sheet (slip sheet)

Sorry I'm not following you - the job sheets and the coloured separator sheets have identical media attributes. 

0 Kudos
Reply
Joe Arseneau
Valued Advisor
Valued Advisor
‎08-05-2016 02:47 PM

Re: iGen 5 -150 with Fiery RIP Cycles down between sets with separator sheet (slip sheet)

Are you setting the weight in the driver or just leaving it as Use Machine Settings?

I've noticed Fiery will cause a machine to cycle between tray calls if the weight is not set in the driver.

Please be sure to select "Accept Solution" and or select the thumbs up icon to enter Kudos for posts that resolve your issues. Your feedback counts!

Joe Arseneau
0 Kudos
Reply
charlieapps123
New Member
New Member
‎08-05-2016 01:39 PM

iGen 5 -150 with Fiery RIP Cycles down between sets with separator sheet (slip sheet)

Product Name: Other - specify product in post

Hi
I run an iGen 5 - 150 with Fiery RIP.
I'm running 300 sets of SRA3 single sided.
Each set comprises 190 sheets and 1 sheet coloured separator.
At the end of each set the machine cycles down and waits for approximately 30 seconds before cycling up and carrying on.
The media attributes are identical for the job sheet and the coloured sheet so I guess it's not fuser temperature.
There is no message in the Active Status List.
Any suggestions would appreciated.

0 Kudos
Reply