Will workplace suite work with a Fiery controller?

[Reproman1984]

Thanks for that very detailed reply, it's very much appreciated.

regards

 R

[XMP_Admin]

Yes those FIERY options are also required for Xerox Workplace Suite to work with the Fiery Integrated Controller, single IP mode.

Some other caveats in this configuration

When using Print Management Authentication:

1. If you want to use Card Authentication, make sure you install and enable the Xerox USB Card Reader Plug-in, can be downloaded from printer support page.
2. After enabling Print Management Authentication, you will have to manually enable on the C60/C70 Login Setting to Convenience Authentication.
3. If you want Alternate Login ability on, you will have to enable this setting: Select Enabled next to Non-account Print to allow users without accounts to access the printer.

Usage Tracking:

4. If you want to use XWS Usage Tracking, Network Accounting, you will have to Manually enable it on the printer.

Finally, you may have to repair the printer to get things to sync up. Always make sure the Fiery is completely up, banner page is printed, before trying any features.

[Reproman1984]

Will workplace suite work with a Fiery controller?

Does the Fiery need to be configured in the same way as Equitrac?

As per below

 Go to Configure > Network > SNMP and specify the following settings:
a) Set Security Level to minimum to allow Set requests and Get requests.
b) In Write Community Name, type Private. EIP applications use Private as the community string for Set
requests.
I